Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
undefined
@spirit-robotics The DWC that the Duet 3 has, will let you control the printer from a web browser, and using a PI will provide the security. https://duet3d.dozuki.com/Wiki/SBC_Setup_for_Duet_3
@alankilian thanks, I will check and return
@rjenkinsgb great info, I checked the data and these look great SE-600-36
@simonjb thanks
@mfs12 Thank everyone for the support, at the end was a firmware issue. I was using the panel due firmware for the V2 version, but my panel is V3. Not it is ok. Thanks again
