Topics created by simobone19

@simobone19 it will probably use the max speed in config, so you could reduce that. or, use G1 R2 Z0 Fxxx in your toolchange file and obviously set the appropriate speed.
See here for more info

@simobone19 the axis limits set by M208 are for the head reference point, which is the point from which all offsets are measured. It follows that if a tool has a positive Z offset, then for that tool to reach Z=0 the M208 lower Z limit will need to be negative. So you can either set your M208 lower Z limit to -1.85mm in config.g or you can adjust the M208 lower Z limit in your tpost#.g file for each tool.