Topics created by Shaun

Think i resolved the problem, replaced the Z motor and seems to be working fine now. Recon its time for complete motor replacement from e3d.

Thanks for the help guys.

@Shaun said in Cura 4.2.1 Config help:

Its as if a setting is telling z to stop when i gets to 0 which isnt the high of the endstop.

Can you explain what you mean by that?

Follow this guide

https://betrue3d.dk/bltouch-on-duet-wifi-configuratio-and-usage/

@Shaun said in Think its broken...:

@Danal said in Think its broken...:

Board swap is on the table form Duet... and may be a good idea... just to possibly avoid the time/hassle, try hooking up VIN (in addition to USB) to a solid 12V or more supply, and re-flash wifi firmware, and re-test, with that power hooked up.

These guys know MUCH more than I... but... something is just itching my brain about power, flash, wifi module, etc, etc, etc. Probably I'm wrong, but it is something quick to try, before getting into a full board swap.

Danal

I have powered the board from the PSU, then connected the usb and plugged this into my laptop. Results are the same.

Ahhh, well, it was worth a try.

Thanks, ill try it tonight.

Good catch guys. Those wrong quotes were stopping the execution of the rest of the config.