Thanks for all the help, ive managed to resolve this issue myself. Nothing like recompiling the Config.g from scratch.
Best posts made by Shaun
-
RE: Wifi/Web Console issues
-
RE: Wifi/Web Console issues
@bearer said in Wifi/Web Console issues:
@shaun said in Wifi/Web Console issues:
M911 S10 R11 P'M913 X0 Y0 G91 M83 G1 Z3 E-5 F1000' ; set voltage thresholds and actions to run on power loss
replace
'
with"
Thanks Bearer, done.
@Admins the configuration wizard sets this so you might want to double check your code.
M911 S10 R11 P'M913 X0 Y0 G91 M83 G1 Z3 E-5 F1000' ; set voltage thresholds and actions to run on power loss
'M913 X0 Y0 G91 M83 G1 Z3 E-5 F1000' as Bearer pointed out should look like "M913 X0 Y0 G91 M83 G1 Z3 E-5 F1000"
-
RE: Cura 4.2.1 Config help
@grizewald said in Cura 4.2.1 Config help:
@Shaun said in Cura 4.2.1 Config help:
M92 X80.00 Y80.00 Z4000.00 E1222.00 ; set steps per mm
4000 steps per millimetre on Z looks like an order of magnitude too high...
Aaaahh yes that should be 400. My fat fingers again. Will fix and test.
-
RE: Change the Router Duet WiFi don't work (ok but....)
I had the same issue, change your wifi security so that you force only WPA2 PSK, dont use mixed mode. You can then use 2 and 5G without any issues.