Topics created by Shaqour

I don't think it's currently possible to chart temperatures. This may become much easier to do with a plugin in DWC in the near future.

Just a follow up note I learned yesterday. I bought a micro SD to micro SD extender to use with a PI 4 in a custom printed case for a digital dash display and it did not boot correctly. A little googlefu led me to https://forum.4dsystems.com.au/node/43404/page2#post55236 . There was a 330 ohm resistor on this new extender board between SCLK and VDD. Crushed (crude but effective) the 330 SMD resistor and it booted fine.

The ribbon cable is only required if you need to use the SD card slot. So perhaps the 4wire cable would be a better option?

If you really do need the SD card, then check Mouser for cables and choose your European country.

https://www.mouser.com/Wire-Cable/Flat-Cables/_/N-5ggm?P=1z0vl9dZ1yzu8m9Z1ytiu0w

@marco13 you've already started your own topic. please don't spam others (especially old ones)

@dc42 said in Auto tune cancelled because target temperature was not reached:

M307 H2

Thanks the problem was solved by making the heater a chamber heater and then tune it

@shaqour said in controlling two heaters in one extruder:

@dc42 can you please advise me what command is used to trigger the fan based on the temperature of the heater?

The command you gave before:

M106 P0 S1 I0 F500 H2 T120

will turn fan 0 on when heater 2 temperature is 120C or more.

Note, Fan 0 output is normally used for the print cooling fan. I suggest you use fan 1 or 2 fr the hot end cooling fan.