Posts made by SEUTec

Hi dc42:

Problem solved.

I have found 2 poor solderings in Ethernet module, RX, and TX pins.

Thank you very much for your support.

Hi:

My Duet Ethernet is detected as DuetWifi, after firmware update.
And do not connect to the local net.

M115 command returns:
FIRMWARE_VERSION: 2.02RC2(RTOS)
ELECTRONICS: Duet WiFi 1.02 or later

I think this is the cause of error when reading the M552 command in the config.g

Hi all:

curl –data-binary "@[output_filepath]" "http://192.168.x.x/rr_upload?name=gcodes/[output_filename].gcode"

–data-binary don't losse the NewLine or CarriageReturns as -d do.
and don't add extra data to the gcode file as -F do.

Regards.

Hi:

I have solved the problem, deleting the deployprobe.g and retractprobe.g.
Now, all works fine with DuetEtherned Firm 1.20.1RC2 (2018-01-01) and WebInterface 1.19.

What is the difference with DuetEthernetFirmware and RepRapFirmware ?
RepRapFirmware if for Duet 0.6 and 0.8.5 ?

I have installed the DuetEthernetFirmware on my new DuetEtherned board.

Thank you for you help.

Regards.

Can you be more especific ?

My printer don't remember that it is configured as Delta Printer and move as
a cartesian printer when I try to print.

Thanks.

Hi:

I have problems with the Auto Delta Calibration when upgrate the Delta printer Firmaware from 1.17e.
The beg.g file seems to be ok, and works fine for 1.17e Firware verions.
But for Firmware 1.19 the heat crash to Z tower.

How can I solve this ?
I need to change samething con config.g file?

Thanks for your support.

Hi dc42:

bossac 1.7.0 is the latest binaries avalable for Linux.

But I have tested BOSSA 1.8.0 on WindowsXP running on a VirtualBox Machine
and it works fine.

Firmware uploaded and now my PanelDue works fine.

Thanks for your help.

Regards.

Sebastian

Hi:

I have a PanelDue v3.0 board that do not works.
I connect to Linux PC by USB connector and the screen remains black.
Then when I try to update the firmware I get this missage from bossac 1.7.0

$ sudo ./bossac -e -w -v -b PanelDue-v3-5.0.bin
Device found on ttyACM0
Atmel SMART device 0x289b09e0 found
Erase flash
done in 0.002 seconds

Write 96916 bytes to flash (190 pages)
[ ] 0% (0/190 pages)
Flash command failed

What can I do with this?

I have a Flash memory damaget chip in this board ?

The 5inch screen works fine, I have tested it with another PanelDue board.

Tanks.