Topics created by SaveThePetko

@savethepetko from the page @Phaedrux linked: d912fd94-b515-4e29-98e0-1fbced35f577-image.png

If it's working reliably for you, then all good, but might still be worth going through that guide properly as stall detection can change a bit as the motors heat up.

@phaedrux said in First home Problem:

Then I suggest you go through that link and tune the settings to suit your printer.

Thank i changed sensitivity and its working fine now .

@savethepetko said in Stall detected on driver(s) 0 1:

Sometimes going home okay when i start the printer and sometimes when i turn on the printer the bltouch wont light red and when i run homeall its go in the middle and stop with this error.

Sounds like your pin might be getting stuck on the self-test?

At the start of your homeall and at the end of config.g try adding these commands to clear any errors on the bltouch and ensure the pin is retracted.

M280 P0 S160 ; Alarm Release and Push-Pin UP just in case it's in alarm and deployed G4 S1 M402 ; Retract probe just in case it's down