Posts made by samlogan87

Very sad to hear. RIP Ian

@dc42 awesome thank you. Will update tonight and give it a try

Hey @dc42

I can't see anything in the release notes as to whether the new input shaping/3.6 release, has been released for the 1HCL boards or is it in development?

Sam

@OttoJiang that is awesome

@BenzinLord3 i run two of those motors with 2 1HCL boards and my encoder cables came pre terminated. See if they can send you some pre terminated ones

@JoergS5 I am very interested in your progress so far. I am about to build a mini mill and will at some stage get a 4th and 5th axis so if you need help testing let me know. I will most definitely be 3-4 months off getting it done as funds don’t allow it at the moment so the project is being drip fed

@Exerqtor I have to agree. I have a few people who run klipper and the screen does make me a bit jealous.

@o_lampe https://youprintin3d.de use to do one. Maybe ask them and see if they can still do them as I can not find them on their website. They were a v6 heatsink that was watercooled

@dc42 ah bugger. It’s just where I currently have the two boards mounted is inside an electrical part off the side of the printer meaning they would need to be about 650-700mm long. I guess I could move the boards. Just a bit worried about heat as I will be heating the chamber at some stage

@dc42 ah bugger. That might be a pain. If I was to use shielded ribbon cable would that work? I see you can buy it, which I never knew about

@dc42 awesome thank you. Are they any better than the quadrature encoders I currently have. I believe they are 2000cpr

Simone has already done a write up on how to set them up.

https://www.modernmakes.ca/3d-printing/cpap-fan-guide

There is a speed output pin which is pin PG.

Hey Everyone,

What’s the maximum recommended length for the ribbon cable?

Cheers
Sam

@oliof missed that. Thanks for pointing that out

What does Odrive use for their brushless motor control? I believe looking at the docs for them and Duet, they are going to be supporting Odrive

@dc42 is there anyway we can “upgrade” the older versions to the newer? Mine has never worked very well even with a very short path between it and the extruder

@dc42 are you guys likely to release a toolboard with a i2c connector?

@dc42 cool. It is looking very promising though. Awesome work. I have a 400x400mm bed and always have issues with bed flatness especially when you really heat it up to do nylons etc

@dc42 when you did that, was the bed warm or are you still playing around with it when it’s cold?

@dc42 do you guys think you will release a new version of the tool board where you put the i2c bus to a plug? Had another look tonight and there is no way I would be able to solder that