Friends!
Found the problem. Together, everything turned out to be quite simple and complicated.
Simple - because in the harness from Duet2 to BLtouch there is a break in the probe control wire. Difficult - because I cut off the printer heads only in the zero position, floating fault. I could not even think that a new 3-wire cable could be defective. The printer hasn't really printed anything yet. Be careful with your choice of wires.
The topic is closed.
Best posts made by RomanVin
-
RE: BL-Touch works for Z home but not for bed leveling?
-
RE: SD card not detected by Paneldue, until I detect via DWC
I registered the M21 P1 config.g in the initial lines and the card slot started working. A little crooked solution but working. Condition - the card must be in the slot. Or, after installing the card, reset the controller.
-
RE: Calibration of Titan Extruder.
@jay_s_uk Thank you very much. Now there is an enlightenment in the head. Live for 100 years and study for 100 years - There is a proverb.
-
RE: BL-Touch works for Z home but not for bed leveling?
@fcwilt The commands M280 P0 S90, M280 P0 S10, M401 and M402 are executed, the sensor works.