Posts made by rodek

Set M574 to S1

Have you followed the instruction here https://duet3d.dozuki.com/Wiki/Calibrating_a_delta_printer

As one who used Marlin, I purchased my first DuetWifi a couple years ago and I would not go back to Marlin, all 3 of my printers at home are DuetWifi, so I maybe a little bias.
Also this forum is a great wealth of knowledge.

for the extruder to work the hot end must be 160deg or you could use a M302 to allow for cold extrusion.

I print PETG with 60 deg. bed temp on PEI and it sticks all to well.

What is the release date of the Duet3 and smart tool board?

Currently I'm building a 400mm X 450mm build area delta printer using a Duet wifi and the smart effector, i was talking with a co-worker about it and some of my concerns 1 being the how long and the number of wires going to the effector. during our conversation the thought of using some form of RF communication from the Duet Wifi and the smart effector so all that would be needed to run to the effector would be a power source, I know that it would require re-design of the smart effector as well as Duet wifi anyhow it is just a thought.

DC42,
Thank you for your help, BTW the Duet WIFI is a excellent board, I read The Duet WIFI V1.03 has fused fan will that save the fan mosfets from a short?

Qdeathstar,

You can E-Mail me at rodek2@verizon.net with your info, I'm Building a CoreXY now so I'm using the board on my old printer to make parts for the CoreXY looks like it will be a few week before I order a new one for the CoreXY. once I have it up and running I will send off to you.
Thank You for all your help.
Robert

Dave, How do you send a PM on the new forum?

Thanks, What is your charge to replace the fan Mosfets?
I have no problems shipping and return shipping.

Thanks
Robert

Can any one help I live in the USA California need 2 of the fan mosfets replaced, On my Duet wifi V1.02 board.

Thanks
Robert

Joe, What motor are you using?

Yes, could use something like this as a replacement for the idler pulley, Could even use it for the extruder to sense the filament travel also.
at power up it could home in the config file as long as the power is on it would know the position at all times even if the motors are off and you move the bed around by hand.
https://www.amazon.com/gp/product/B00UTIFCVA/ref=crt_ewc_title_srh_1?ie=UTF8&psc=1∣=A2CH56PPVFOUBF

It would be nice to have a encoder of some kind, a optical scale or rotary encoder