Posts made by Reaperrhs

@alex-cr thanks, i gonna check that, the problem is that I'm new with macros and the hole RepRap thin, hopefully, I can understand

Hi everyone! I apologize, i speak spanish.
I need help configuring my printer heat bed, i have a 110V 310x310 750w silicone bed installed, I use an SSR with it, the problem is that when I set the temperature my board shot down the bed because it says (Heater 0 fault: temperature rising too slowly: expected 2.27°C/sec measured 0.78°C/sec) but as far I can see temperature rises just fine, what I need to do to change that configuration and give more time before shootdown my heat bed?

i think is the thermistor, i plug a didn't one and is reading, so..i really want to thanks for the help, you guys get this thing working, big thumbs up to you guys

to be exact is a silicone pad that I using on my heated bed

i comment out the one i have and copy
M308 S0 P"temp0" Y"thermistor" T100000 B4138 ; configure sensor 0 as thermistor on pin temp0
Still reading -273

the sensor on my bed is reading -273, I change the pin on my board to 0 and i left config as it is

thank you guys, i will never get it done on my own, one more thing my heated bed has a ntc 100k, I need to configure that to, can you guys help me?

@Carlo HOTEND Working Thanks!!!

@Reaperrhs the one on the top is for my hotend, is the one with the PT100

@Reaperrhs ; Heaters

M308 S0 P"spi.cs0" Y"rtd-max31865" ; configure sensor 0 as thermocouple via CS pin spi.cs0
M950 H0 C"out1" T0 ; create nozzle heater output on out1 and map it to sensor 1
M143 H0 S450 ; set temperature limit for heater 1 to 450C
M307 H0 A512.3 C269.6 D3.6 S1.00 V24.0 B0 ; disable bang-bang mode for heater and set PWM limit
M308 S1 P"temp1" Y"thermistor" T100000 B4138 ; configure sensor 1 as thermistor on pin temp1
M950 H1 C"out0" T1 ; create bed heater output on out0 and map it to sensor 1
M143 H1 S280 ; set temperature limit for heater 1 to 280C
M307 H1 B0 S1.00 ; disable bang-bang mode for the bed heater and set PWM limit
M140 H1

@jay_s_uk

@Carlo no luck so far, i have to double-check everything, also.. can you tell me whats define by the S1? because that's the only thing we have different

@Carlo yes, center terminals

@Carlo i have two wires, also the jumpers are in place, the two wires are connected in the right hand of the daughterboard

@Carlo thanks, let me see what I'm missing (are you using a daughterboard to??)

@Carlo can you show me the hole config for heaters? just to compare with mine

@jay_s_uk i double-check, there is no space, you can see it in my main post, I copy my configuration, the daughterboard is connected on the mainboard duet3d and my sensor is connected to the rtd1 on the daughterboard

@JoergS5
thanks for helping, i have one question because I'm learning as I go, for the M308 you replace the existing command or create a new one?

@jay_s_uk on the daughterboard I'm using the rtd1, by the way, I'm using the temp_0 for the sensor