Topics created by Ravs99

@Ravs99 the CAN bus drivers are highly tolerant of over voltage so the Mini5+ will be fine.

The failed component on the tool board is most likely the TMC2209 driver chip.

@chrishamm Will do. Thank you for the prompt response.

@ravs99 You'll see them in the status page when running a print - bottom left corner

Sliders1.PNG

Sliders2.PNG

@ravs99 I guess it would be possible to implement torque mode on the 1HCL, by keeping the motor phase currents 90deg ahead of the current position, and controlling the current to give the required torque.

@hebigt thank you!

@ravs99
Sorry, I can't say how a pallet extruder is controlled because I don't have one or am not familiar with it.
But I think it's controlled like a motor by a normal extruder.
But how the steps are supposed to be calculated is a mystery to me. 😀

Someone will definitely get in touch who can answer your question.
Post some photos, I'd be interested.

Google Translate
----- Original Text -----

Sorry, wie ein Pallet-Extruder gesteuert wird kann ich nicht sagen, weil ich keinen habe bzw mich damit nicht auskenne.
Aber ich denke der wird wie ein Motor von einem normalen Extruder angesteuert.
Aber wie die Steps berechnet werden sollen, ist mir ein Rätsel. 😀

Es wird sich bestimmt jemand melden der Dir die Frage beantworten kann.
Poste gerne mal ein paar Fotos, es würde mich interessieren.

@phaedrux oh right. i forgot about that. haha. Thank you for the help

@engikeneer yeah thats what I was thinking of aswell. Going to try it later today

@ravs99 most likely the move you have requested cannot be executed at the requested feed rate without exceeding the 300mm/min maximum extrusion speed that you specified in the M203 command in config.g. So that 300mm/min is the limiting factor.

@ravs99 in what way is the 4 wire fan connector not working?

@ravs99 good news. hopefully you get your config sorted