Posts made by R4ffers

Just thinking out loud here, but what if you had a coil mounted upside down next to the bed. Use that one to scan the nozzle. Mount one on the toolhead for scanning the bed. That way it wouldn't matter if anything was stuck to the nozzle. Would it be accurate enough to set Z height that way?

@T3P3Tony thankyou

@dc42 are there any drawings available please? I'd like to look at making a mount.

@Sindarius Euclid is how I do it

I definitely want to give this a go

@Phaedrux yep, this happened to me too. Stuck manjaro on an old laptop instead.

@wbrokow1 Hi, so I'm currently running these values on my V2.4 350mm :

M566 X500 Y500 Z500 E450
M203 X40000 Y40000 Z3000 E7200
M201 X7000 Y7000 Z350 E2000
M204 P12000 T12000

I use a Rapido, 0.5 nozzle and Lgx lite which work well at these values for me. Double check your slicer settings.

@wbrokow1 post your config.g so that people can check and and advise.

@jay_s_uk that's excellent

@oliof did this work ok.

@blt3dp This might work for you.
https://www.printables.com/model/216239-voron-0-front-corner-12864-lcd-mod

@o_lampe Enraged rabbit carrot feeder, similar to smuff. It's a Multi filament unit.

@NeueKlasse excellent work

Prusa slicer and super slicer are my main go to slicer

@alankilian it almost seems like a calculated move to wait until all new licenses purchased were over 12 months old. Nobody then gets a free upgrade.

@sinned6915 Hi, which connections / pins have you used to connect the encoder to the paneldue? Thanks in advance.

@JADoglio 1lc toolboard is awesome for me

@Herve_Smith that's them ordered too. many thanks

@Herve_Smith which sensor have you used and is that a spring?

@Herve_Smith awesome thanks for this, just ordered a set