Is it possible to set a custom timeserver on Duet2 Boards?
This is for an use case where the duet2 Board has only limited internet connection and therefore sadly doesn't continue to count the time when its off.
Latest posts made by qurt
-
Use Custom Timeserver Duet2
-
HF and Industrial Application
Are there any concerns using the Duet3D hardware for Industrial Use cases?
My main concern is the HF Interference, e.g. if you are using long Cables for CAN. -
What is the cycle speed limitation of a Duet3D setup?
I know this question is a bit vague and also maybe more than just one question... and I am mainly interesting of the future direction.
So I know that it is possible to run Klipper on the Duet Firmware and I know that Klipper seems to be often more Bleeding edge while Duet is more polished 1.From my instinct and understanding: Klipper is doing all the calculation on the Computer (e.g. the Raspberry Pi).
A) Is this also true for the Duet?
What I tried out is: using a Raspberry Pi 4 and a Raspberry Pi 5 with Duet and run a speed test gcode up to a limit/problem: and starting with a speed ofS25000
I run on both units into Hiccups.
(Note: There is a claim that it doesn't matter to much for steppers - but well I want to use servos... 2).
B) Are the Hiccups an issue?
C) Are they maybe caused the DuetBoard or the bus system and not the Compute unit?
D) are there any performance improvements from switch to Klipper (and a powerful computer)?