I'm hoping there is a way to home my printer, run some rapid movements, then home again and output any positioning error. This would help me diagnose missed steps or fault end stop switches. Additionally it would be nice to insert this into a homing sequence that homes the printer twice and compares the error against a predefined "acceptable" error which can trigger some action. Homing again, canceling the print, etc...
Posts made by qman3399
-
Detecting missed steps during homing sequence.posted in General Discussion
-
RE: Manually updating resurrect.g without having to pause the print?posted in General Discussion
@Phaedrux I ordered some caps to see if that helps the issue. I'd like to be able to manually save the position too though, in the off chance that the power loss doesn't work or something other than low voltage causes the board to reset. Maybe something like G60? But it doesn't seem like the restore position from G60 saves after a reset.
-
Manually updating resurrect.g without having to pause the print?posted in General Discussion
I'm curious if there is a way to update the resurrect.g without pausing the print or hoping the M911 is able to update it during power loss. Could I save the location every layer so that in the event of a power failure it will restart the layer, printing some of it twice, but for the most part picking up where it left off?
-
MultiDuetWebMonitor Troubleposted in Duet Hardware and wiring
I stumbled upon MultiDWMC while searching for ways to control all of my printers more easily. It doesn't seem to be working anymore and from what I can tell it's from the implementation of CORS on more recent firmware releases. Is there a way around this to get DWMC working again? My printers are running RRF 3.4.0.