Posts made by printingmark

@littlehobbyshop that did the trick thank you very much

homeall.g homez.g

if I move the axis they go in the right direction
when i do home all the z axis goes up instead of to the end stop i have seen

sorry for my
English

Hallo everybody
i had to remove my bltouch (defect)
changed the configuration and now the printer homes and try to print about 10 cm above the bed
can sombody please tel me what i am doing wrong
config.g
endstop works

@Phaedrux thank you

@baird1fa thank you

Hallo everybody, hope you are doing well
i have some problems with my BLtouch, due to conect problems i had to put a backup back on the board, now if i try to probe the bed the first two probes are oke the thirt probe it hits the right site before probing and back on the left side it tries to probe ousite the bed, what could be wrongconfig.g
thanks

@droftarts you where on the right track,one of the endstops was broken i saw movement in it while checking te connection
thank you

@droftarts i will check thanks

homez.g homey.g homex.g homeall.g config.g

config.json

this morning it started all over again,repeated all stps no succes

for the moment all is working, thank you verry much all for the help

@bearer i will try, thanks

@whosrdaddy done that but it didnt helpconfig.g

@bearer every time i press home or G0 X120Y120 it is going to a differend place
the belts and grub screw ore i think oke
but i have now idea how to check the motor current

Hallo everybody,
i am beginnning to get desperate
trying for more than a week now, got help here a few days a go it workt for 2 prints and now every time i want to print ik starts at a differend place on the bed
i have a ender 3 pro, bed is 235x235 it has a bltouch, i am not verry technical, so please be patient with me config.json

@JoergS5 the speed did thetrick, thank you again

@JoergS5 i will thank you

@JoergS5 i will try set de speed slower maiby it helps, thanks verry much for your time

@JoergS5 only x and y