Topics created by Polyneutron21

@Polyneutron21 Order link sent.

Please send an email to warranty@duet3d.com and CC your reseller. Include a link to this forum thread and the details of your original purchase. You'll receive a reply with a form to fill out.

The different B values where the key. I tried the probe on temp1 and it worked. The hot end tool board was 23,6°C which is now controllable. I checked the pin connectors and plugged it into Temp0 and after booting it up it works their as well. B values affect the reported temperature.

@Polyneutron21 change the direction (S value on M569) on the z drivers going in the wrong direction

Seems like another possibility is that the ribbon cable isn't fully seated, photos would be useful.