Posts made by Odie9

What do I pick as a model to configure in the config tool? The Duet WiFi is set up for a delta now, I need to change it to cartesian. Thanks for the help.

It's not listed in the config tool.

Will 3.x run on Duet WiFi v1.0 hardware?

I have a Duet WiFi v1.0 with RepRap firmware v1.2 loaded on it. I upgraded to a Duet Wifi in a homebuilt delta. I want to reuse the old v 1.0 in an Ender 5 Plus. I tried to use the RepRap Configuration Tool to create a new firmware but the hardware isn't supported by it any more. Anyone have a 1.2 cartesian configuration they could post? If not, any other suggestions on how to use this board for a cartesian printer?

TIA
Odie9

Thanks for the responses. I followed those guides and upgraded all the pieces appropriately prior to posting.

I rebooted a few times last night with the same results. I had a couple of bad network SSID's in due to pronterface capitalizing everything. I had the correct one as well though. I deleted the bad entries before I posted last night and then rebooted a few times with the same results.

I just booted the printer up a couple of minutes ago and it connected to WiFi on it's own. I guess it healed itself overnight, lol. Maybe my router was holding on to something that needed time to reset or something.

Anyway, it's working now, thanks again for the help.

Now back to printing an Ironman helmet for Halloween!

I updated the firmware on my v1.0 Duet WiFi from 1.17 to 1.20. If I send a M552 S1 in pronterface it connects to my WiFi fine. If I disconnect the USB cable and reboot the Duet WiFi it won't connect to WiFi. I commented out the M552 S1 line while installing the firmware but it is enabled now but doesn't seem to be having an effect. Any idea on what I'm missing? Thanks in advance for the help.