Duet WiFi in Ender 5 Plus
-
I have a Duet WiFi v1.0 with RepRap firmware v1.2 loaded on it. I upgraded to a Duet Wifi in a homebuilt delta. I want to reuse the old v 1.0 in an Ender 5 Plus. I tried to use the RepRap Configuration Tool to create a new firmware but the hardware isn't supported by it any more. Anyone have a 1.2 cartesian configuration they could post? If not, any other suggestions on how to use this board for a cartesian printer?
TIA
Odie9 -
@Odie9 said in Duet WiFi in Ender 5 Plus:
I have a Duet WiFi v1.0 with RepRap firmware v1.2
if you are setting up a new printer just update to 3.1.1
you need to update to 3.0 first. -
Will 3.x run on Duet WiFi v1.0 hardware?
-
It's not listed in the config tool.
-
@Odie9
yes -
What do I pick as a model to configure in the config tool? The Duet WiFi is set up for a delta now, I need to change it to cartesian. Thanks for the help.
-
go for custom and on the next page select cartesian.
you will replace all files with the newly generated files.
this is a good guide for a ender 3
https://duet3d.dozuki.com/Guide/Ender+3+Pro+and+Duet+Maestro+Guide+Part+2:+Configuration/38you can go along with most of it, replacing specifics for your printer, eg size and thermistors
