Topics created by norwestie

Iif your bed heater takes a long time to heat up and cool down but the temperature readings are very stable, then as @jay_s_uk says you can use a Y parameter lower then the default value (5) in your M303 command.

@norwestie this issue is fixed in RRF 3.3.

@norwestie said in Can't upload to printer:

@norwestie But again, can't upload to card

That's unfortunate. You will be getting an email regarding your warranty claim shortly.

The easiest way is to upload the full zip file to the system tab in DWC.

https://github.com/Duet3D/RepRapFirmware/releases/download/3.4.5/Duet2and3Firmware-3.4.5.zip

If that still doesn't do it, you can to a more manual process here:

https://docs.duet3d.com/en/User_manual/RepRapFirmware/Updating_firmware

I am using a similar probe. You can't tell if it is a SPST or SPDT snap action swtich unless you tested to see if the switch is NC or NO. That will make a difference too. NC is prefered. Hook up a test light or DMM and check. The config is different if it active low or hgh.

What is your M574 config line look like?
https://duet3d.dozuki.com/Wiki/Gcode#Section_M574_RepRapFirmware_Num_3

RepRapfirmware gcode flavor. Relative extrusion. Firmware retraction if you want.

@norwestie said in Carriage won't reach bed:

@droftarts said in Carriage won't reach bed:

M665 R134.4 L271.5 B116 H283

Thank you again. This is all Greek to me so I rely heavily to you and the community for help.

i am greek and most of these looks greek to me to ....

the M665 is what defines a printer as a delta to my understanding.

M665 Rxxx( is the radious of ur builded printer the internal one), Lxxx( the length of the rods that hold ur effectors) Bxxx( is the radious of ur bed) abd Hxxx( is the height of ur nozzle to the bed when the limit switces are enabled) .

@phaedrux To answer your question, I bought it from Filastruder a month ago

See some example of wiring here maybe you'll see where you've gone wrong?

https://duet3d.dozuki.com/Guide/Ender+3+Pro+and+Duet+3+Mini+5++Guide+Part+1:+Wiring/87