Topics created by noisettetbou

@dc42
@Argo
I've tested the new firmware and it's ok. No bug with M291. The print was well paused during all the process.
Thank you very much !

@noisettetbou you mad e that seperate circuit or just added psu can you take a oic of your setup

@dc42 @Phaedrux @oliof
dc42 has reason. My voltage is enough for each axis but limit for all axis in the same time.
So i've decided to installing a Duex5.

@shiga . OK, thanks a lot.

@noisettetbou You probably meant M584 and not M594.

Ok, thank you.

OK. Thank you. 👍

@dc42 Hi, i've tested some thing such as, different directory for the purge macro, even put it in sys folder, always the same thing... I also put it out of the filament-change.g, so in my pause.g, i run the purge.g after the filament-change.g, it does exactly the same thing... I also try without the purge, i goes really good ._. don't know why it does that ... maybe i'll try something else later if i got some idea. Maybe i should delete the config.json and config.g.bak but should do anything.

Thanks for your time 🙂

@dc42 Thanks a lot. I'll trying that.

Nice, glad it worked out for you.

It's OK ! Thank's a lot for your answer and your products