Topics created by NicoLab28

@nicolab28 said in First T0 in gcode, does not work:

The problem with the T-1 is that if there is a filament loaded at the beginning of the print, it will unload it.

You can use T-1 P0 to deselect the tool without running the tool change files, if you don't need any part of the free file run.

There is a method / trick for heating the hotend without selecting a tool?

Use T0 P0 to select tool 0 without running any tool change files, then you can heat it.

Looks pretty nice! I am currently eyeing the SMuFF, but that is active and not passive ...

ok no worries, if its a custom one it'll be different setup to the prusa version so take my advice lightly as its not the same

OK, thanks,
I will test, although I found another solution using the mechanical torque, rather than the power of the servo.

Thanks also for the little tip of electronics.

As I understand it with a DC-DC, there is no separate ground problem, and the resistor is only used if for example, I plug in usb, without the VIN. Because in this case, there would still be current in the servo signal pin.

Conditional GCode is scheduled for implementation in firmware 2.03.

Did you get the MMU to work with duet ? 🙂