I ordered this when I just replaced mine. Worth it.
https://www.digikey.com/product-detail/en/molex-llc/0451320610/WM16121-ND/6208008
Mouser also has a higher end one:
https://www.mouser.com/ProductDetail/Molex/245132-0610?qs=sGAEpiMZZMsB9HsreUc%252biT1kJrdVkr5yWzvQ3Oh8lVY%3D
And both of them sell just the connectors if you want one. Microfit Molex 3.0 6 circuit
@paboman TBH I dunno that this is best way to do it but I basically took off the jumpers(required to remove for 4 wires) and just made a 4 wire connector to those pins on the daughter board. As for the wires otherwise, do you have a Smart Effector?
@klcjr89 Do you still wire the same? Need a diode for it?
@klcjr89 Nice, may grab one of those and use the other pump on one of my lesser used printers.
The digikey are perfect, the cable quality itself is really nice for the fast/constant movements of the delta effector so I'm really loving it, looks nice too. I just had way too much issue crimping the cat6 double wire and getting it to fit even though I have a good crimper. I've never really had that problem before. Also the cable fits a lot better(clips in and out with no pressure)