Topics created by misterj

Please send an email to warranty@duet3d.com and CC your reseller. Include a link to this forum thread and the details of your original purchase. You'll receive a reply with a form to fill out.

@misterj said in z-probe reading at 1000:

M558 P5 l0 R0.7 F400 X0 Y0 Z0 ; (digital mode, NO/NC, delay, speed, not used as axis endstop

I have a SN04 probe and it was doing the same until I changed invert command to (I1) on the M558 gcode

@misterj With dual drive gears sometimes too much tension could lead to problems. I'd check whether you have adequate cooling on the heatbreak and whether both drive gears are actually aligned.

Looks like the difference between the two fans is very significant.