Thank you for your help

Mike

Hi all were do I set up bed leveling in Duet???
Mike

we now have everything working, but no power to steppers. can I send my board back for you to test please.
Mike

I am still getting this message can you help please?

Mike

It has been over three months since I rebuilt my printer. I still am not working is there no easy way just to get started without all the messing I am doing?? Would it be easier to buy a new Duet as I have made one big boob some were. I don't do computers if I have to mess with changing to many things, I am sick of the message This printer only supports binary commands. when I put in M997 S1 0r 2. Is there away someone could connect to my computer and fix it for me or do I find an other controller??????

This is were I have got to,
Still don't understand what this means

READ: G90
Testing binary communication protocol...
Connected to machine!
SENT: d501015e
READ: d501015e
This printer only supports binary commands.
Disconnected.
Attempting connection at \.\COM3...
Testing plaintext communication protocol...
READ: G90
Testing binary communication protocol...
Connected to machine!
SENT: d501015e
READ: d501015e
This printer only supports binary commands.
This printer only supports binary commands.

this is what I get when I try to use M997 S1

Mike

Hi, As I thought I am going round in circles, I re built my printer from a Delta to a carcassen but can not up grade the firmware or do anything. When i first rebuilt I could connect with wifi but and only the limit switches didn't work now I have nothing. I have down loaded the firmware on the the sd card but I can't connect using usb to upload on to the board. I think it is M997 S1.
where do i go from here it is now tree weeks since the rebuild. I did warn you am OK with building but things like this stump me.

Mike

Is there any way I can buy a card with this done? I am the worlds worst at doing this sort of thing I am more of a build man than a techno man. Thanks Mike

Hi, firmware 1.7 Reprapfirmware.

mike

Hi I have had my duet 3d wifi for some years now but have changed my printer and laptop I just can' t seem to remember how to get going again. i can see a control panel I have always used but it bis a simulation and wont let me do anything please help.

Regards
Mike