Topics created by Mike 1

@Mike-1 said in Thermistor issues:

and a daughter board

which daughterboard exactly?

your link seems to indicate that the new temp sensor is a K500 thermocouple, not a PT100. Are you saying you swapped it out?

Photo of your wiring?

Bambu Lab may also use a similar algorithm to achieve flow calibration.
https://forum.duet3d.com/topic/33667/auto-pressure-advance-turning-by-hotend-pressure/28?_=1716527681549

@Mike-1 said in Muti tool setup:

Warning: Obsolete use of S parameter on G1 command. Use H parameter instead.

This is because you are using S instead of H in the G1 command, see:

https://docs.duet3d.com/en/User_manual/Reference/Gcodes#g0g1-h-and-s-parameter

@OwenD

I am using a 0.6mm steel nozzle and it has some issues with thermal conductivity (small parts are fine, big parts need a higher temperature 265°C + x for PETG with the risk of burend material) so I am thinking about going back to 0.4mm as these have much less issues and slicers have problems with differernt diameters at the same time. The alternative would be a CHT like nozzle. I have to think about it.

M207 might be a good idea.
I am struggeling with ability to use absolute and relative values for the extruder in the gcode.
I don't know how the gcode interferes with M207. Issue is the time from the wiping station to the printig object. So the correct way to do, would be to bring the prinhead back to its position and then unretract. But one part is driven by the printer and one by the gcode.

Unfortunately I will leave my printer behind for a few weeks on Thuesday again.
If you have a good idea to fix it, I would really appreciate it. But I am short in time and will have to make a break 😥 .

Thanks!!!

@dc42 Thanks! Issue can be closed 🙂

@gloomyandy
Thanx!

Topic can be closed 🙂

@MIke-1
This here at the very end fixted the issue!

G1 R2 Z2 F2000
G1 R2 Z0 F2000

Thanks to the Duet Team!

Fixed! Thanx!

@MIke-1

At least
M915 H200 X Y S3 R0 F0
was missing.

Issue is fixed

@MIke-1 said in Thermistor 104nt-4-r025h42g:

Sensorless homing is crashing at least for the x axis.

Might be a good idea to start a new thread about this issue. Include your config.g and homing files.