i updated to the latest firware last week and im printing now for a week and im not getting constant disconnects.

But i did notice that opening g-code files will disconnect the web interface.

Thank you guys !

my duet has decided that it doesnt want a update i think,
I cannot connect for long enough to upload the new firmware.

Is there a reason to think new firmware will fix this problem ? Was there a bug with the wifi connection thats fixed in the new firmware?
I heard the update you firmware answer before and i did update it back then but it didnt make any difference.

to be honest i'm a bit done with the duet, the board is working great only the wifi is really bad, (big problem for hardware that can only be controlled via wifi) could i connect a different wifi board or maybe an ethernet board ?

Do new Duet wifis have a different wifi chip ? Or is it just as good/bad ?

Hi,
Im using the duet WIFI for around 3/4 years now and i still have frequent connection problems.
If i start the duet i can connect fine (most of the time) but after like 5 minutes or so it will disconnect me, and this keeps on going. .
Sometime i need to restart the duet because i cant connect anymore.

I spend a lot of time to fix this and finally give up, this was +/-2 year ago .

But i still hope someone can give me solution for this, because its still very anoying.

Im running this firmware:
Firmware Name: RepRapFirmware for Duet WiFi
Firmware Electronics: Duet WiFi 1.0 or 1.01 + DueX2
Firmware Version: 1.21RC1 (2018-01-25)
WiFi Server Version: 1.21RC1
Web Interface Version: 1.20

ik wil try the 1.21RC1 firware when its ready,
but i dont think i have a problem with the wifi connection , i tryed the M111 command but it didnt show any problems with the wifi connection , my duet shows up connected on my router and i can also ping it. it looks like the http server is closing the connection..

but DC42 to whole point of having the duet wifi for me is that i can control it from a distance and the active development of the firmware to get even better printing results.

i would like to have some help to get things going again with the new firmware.

Dc42 what do you mean worked best for them? I liked the new version, i hope my problem wil be fixed.

I do not think that these AJAX errors are caused by your wifi connection but by the firmware (Firmware 1.9 and up)
I had them all the time after upgrading, im back to the old firmware and dont have them anymore
see also my tread :
https://www.duet3d.com/forum/thread.php?id=3831

i hope this will be fixed

its running for 5 hours now and still no AJAX errors.

So im happy i can print again, but if its not fixed , im stuck with old firmware….

i installed the old firmware, and untill now i didnt see any Ajax erros .

it looks like there is a bug in the 1.19 and later firmware. or my board is broken.

would be nice if this is fixed so i can also enjoy the new features.

i will upload the old firmware today and hope it will work.

• DuetWifiFirmware-1.17e
• Duetwebcontrol-1.14a
• DuetWifiServer-1.03-ch