Hello,
i would like to get a interval beep output when the filament at the filamentsensor goes out at my Duet Wifi with a PanelDue7‘.
Is it possible to stay in pause.g with interval beep until i confirm a message at panel due?
Latest posts made by Micha.
-
Intervall beep when filament run out of sensor
-
RE: Magnetic Filament Sensor NEW Issue(s)
Hello,
where i can buy actually one magnetic sensor in germany?Micha.
-
RE: Where can i get a new heatsink?
@oliof did you know the measurement of the pitch?
-
RE: Where can i get a new heatsink?
@Veti Thanks a lot. Thats what i am searching for.
-
Where can i get a new heatsink?
I need a new heatsink for the smart effector. Where can i get one as a sparepart? Maybe in a german shop?
-
RE: Use of two smart effector and realize this
I will retry as follows:
Make a correct setup for one effector and download all configuration files as a .zip.Then i modificate the settings for the second effector and download this settings as a .zip.
So i can upload the .zip file to the board depends on witch effector i will use.
Could this way be work. What do you think about it?
-
RE: Use of two smart effector and realize this
Thanks for the reply, so far.
I think the only dimension differences of the effectors are the z-hight.Is this a problem for the auto- delta calibration?
Must i do one calibration for each effector? Or can i calibrate one effector and the software correct the calibration for the other effector with the other z-offset value? -
Use of two smart effector and realize this
Hi,
i´m Micha. from germany an use a duet wifi board on my modified Anycubic Predator.Actually i build up two smart effectors, one with an e3d hotend, one with a volcano.
Now i will change the effectors in depends of the printjob i want to do.What is the right way to realize this with the duet reprap firmware?
Must i use the tool funktionality for this? Or must i hold two complete sets if configuration g- files und change them in the root if i change the effector?
Greets,
Micha.