M98 Pconfig.g.txt M122.txt
Not sure why it says over powered... everything is setup correctly there also. the cartridge is brand new.
Latest posts made by MdMx220
-
RE: pt1000 Sending back fault
-
RE: pt1000 Sending back fault
@Phaedrux @mendenmh
100% sure it's a pt1000.
I checked the wiring, it's 1113Ohms @ 28C.
But, the wiring for the temp sensors were backwards, it's my bed with that fault not the hotend -
pt1000 Sending back fault
It's been a while since I messed with my printer. The last thing I tried to do was getting my pt1000 sensor to work, which it doesn't.. still cannot figure out what is wrong.
It is wired into e0 temp.
Any help would be much appreciated!! config.g
-
RE: E3D PT1000 Fault RRF 3.1.1
@Veti I got no resistance. Thanks for reminding me that I should troubleshoot hardware also.
-
RE: E3D PT1000 Fault RRF 3.1.1
Even with the 'T' parameter removed, the fault stays the same.
M308 S1 P"e0temp" Y"pt1000" ; configure sensor 1 as thermistor on pin e0temp M950 H1 C"e0heat" T1 ; create nozzle heater output on e0heat and map it to sensor 1 M307 H1 B0 S1.00 ; disable bang-bang mode for heater and set PWM limit M143 H1 A157.3 C237.7 D4.4 S285 ; set temperature limit for heater 1 to 275C
-
E3D PT1000 Fault RRF 3.1.1
Just recently purchased and tried to install the E3D PT1000 Sensor for my hotend.
I am getting a fault with the Current reading 2000.0 C
I have the sensor wired in to E0_TEMP.
M308 S1 P"e0temp" Y"pt1000" T110000 ; configure sensor 1 as thermistor on pin e0temp M950 H1 C"e0heat" T1 ; create nozzle heater output on e0heat and map it to sensor 1 M307 H1 B0 S1.00 ; disable bang-bang mode for heater and set PWM limit M143 H1 A157.3 C237.7 D4.4 S285 ; set temperature limit for heater 1 to 275C
-
RE: Anet A8 Fan Issue
The fuse was checked with multimeter, It's not blown.
I am reading 7.6V across the fan pins. With an external 5V from a buck.
I probed my V_FAN pin, verified 12V from PS.
-
RE: Anet A8 Fan Issue
Do I need to create the pin numbers using M574? I'm doubting this question, but it's a long shot for me right now.
-
RE: Anet A8 Fan Issue
@Phaedrux
Wouldn't one fan or the other turn on, with the way the config is setup now? -
RE: Anet A8 Fan Issue
@Phaedrux
Extruder fan is always onParts cooling fan is F1