Topics created by Martin S

It looks to me that you haven't run delta calibration, or if you did then you didn't save the results. See https://duet3d.dozuki.com/Wiki/Calibrating_a_delta_printer.

Problem solved !

it was the wrong pin for the Signal.... i missed it by one. 🙂

best regards
martin

U @dc42 are just genious !
it ist not just that u sir knew already that my wiring was wrong. U also found a simple way to show me were my fault was !

So. for the moment my homing is working as it should.
I follow the next step and try to figure out how to work with the z-probe.

thank you very, very much for your patience and help.
best regards
Martin

I think we can close that thread. Board was defect.
I open a new Topic for my Endstop Issue.