Topics created by Marshal

@norder Prusa slicer has had broken vase mode for years. It used to work fine, but at some point, changes made caused the vase mode to create a seam in the prints. If you don't want a visible seam, Prusa slicer isn't the one to use.

@marshal

GREAT!

I'm glad you're running again.

Hi,

i continued testing this evening,

Upgrading Toolboard to 3.2.2 (all system 3.2.2) --> issue remains Upgrading all to 3.3beta3 --> issue remains

Currently i am using a 3DTouch (BLTouch clone), with 3.3beta3 i had some events, where probe was not deployed, or was triggered before touching bed. Which seemed more an issue of the sensor after the previous "touch" than anything else.

I have extended retractprobe.g
from:

M280 P10 S90

to:

M280 P10 S90 G4 P200 M280 P10 S160

I have done 3 test prints in a row now, no issue yet.
Maybe the sensor was putting noise on Toolboar.io0.in?

More prints will tell if it is fixed like this. Maybe a BLTouch will replace the 3DTouch soon.

@marshal, thanks for the update. I'm glad this is resolved.