Topics created by kmart

@droftarts

I think what you really want is to set M143 to turn off the chamber heater when it gets to the set temperature.

Yes, this is exactly what i want to do and kind of what i figured was going on once i started setting my chamber temperature to 30C instead of 40C.

How do you set the chamber temperature currently?

Typically in the slicer

So what you said makes sense and was what I was going to test next, just lowering the S parameter value of M143.

Thank you for this info.

@dc42 sorry if I wasn't clear but that's exactly how I have it connected.

Thank you

@kmart said in inconsistent Z movement:

maybe they're causing some kind of additional resistance.

That's typically what they do. Sometimes to the point of binding if the motor isn't powerful enough. Backlash is typically not a problem on Z. So I'd try removing them.

That did it, embarassed i didn't see that but thank You!