Topics created by keith

@HarveyS https://www.trinamic.com/products/integrated-circuits/details/tmc2660-pa/

@phaedrux said in Cura 4.2.1 to Duet2Wifi plugin problem.:

Cura has a checkbox for relative extrusion now. May have to search the hidden settings for it.

Just found it in 'Special Modes' , usually hidden.

Ian

@keith

Haha awesome! My buddy had the same problem with his $5000 printer. He'd been calling tech support for over half a year, and their only way of solving the problem was replacing all the electronics. I came over one day, noticed it only works on some parts of the bed, and figured it was a broken wire within the same day. Depending on the position of the axis, the wire would either connect or disconnect (like flexing headphone wires after they broke). I'm glad you found the issue on your printer 🙂

Cheers.

Please ask Filastruder to replace your Duet. Either the driver chip has failed (if it really is hot), or it is not soldered down properly.

Recreate the retract probe file from scratch just to be on the safe side.

When it's doing the self test the probe goes in and out repeatedly no problem?

@bearer

Left it alone for a few hours, came back and tried again. It works. Have no idea why.

Back to not being able to connect to the Duet2Wifi on Mac