Best posts made by k3lag

I finally got my new panel and it looks great.

I ordered this panel from www.buydisplay.com: https://www.buydisplay.com/7-tft-lcd-touch-screen-display-module-800x480-for-mp4-gps-tablet-pc

Be sure to select the '7“Resistive Touch Panel Connector Type FPC' option.

The most difficult part of the replacement was getting the old panel off the board. The panel and cables are connected with double sided adhesive and care is required to make sure you don't damage anything. Have some replacement two sided tape on hand to attach the new display.

Larry

I installed 3.1.0 on my Duet2Wifi a bit ago and since then it has restarted several times. Once in the middle of a print and several times while idle. Here is the M122 output:
console-2.txt

Apparently I accidentally selected the wrong option when I ordered my board and I got the 18-bit RGB version. After talking to buydisplay I choose to rejumper the board for 4-pin SPI and it works now.

I am having a problem with it freezing after a few minutes of operation. Right before it freezes I see the WiFi icon turn yellow momentarily then it goes back to green and it's frozen at that point. After a reset it will work again for a while then do the same thing. I have an Orbi mesh WiFi network and I wonder if it's somehow struggling with that. When I go to pick a WiFi network it shows each of the 3 Orbi bases as separate networks and there is no way to tell which one you are picking. Don't know if that's the problem or not but I plan to fiddle more to see if I can figure it out. Never mind. I don't use the filament directory so once I added a filament file it was happy.