Using DuetWifi with all latest firmware and web UI - no matter what I try to upload I get this error:
https://www.dropbox.com/s/p67q42qv4zg63xl/2017-03-16_17-20-47.jpg?dl=0
any ideas ?
Using DuetWifi with all latest firmware and web UI - no matter what I try to upload I get this error:
https://www.dropbox.com/s/p67q42qv4zg63xl/2017-03-16_17-20-47.jpg?dl=0
any ideas ?
Nice!
(off topic) how are you finding the split bottom corners for frame assembly? Is the advantage just that they are easier to print?
Cheers
Tony
Thanks.
I was simply wanting to double up on the bottom structure for what little extra rigidity it would provide and to give me plenty of space in there for power supply and other components - so you guessed correctly about being somewhat easier - I only need to print a single part design for all 9 corner pieces. As you can see in the photos, I downsized the lower section of my new 200mm delta to use 20x20 and designed the 20mm corner piece for it. As far as assembly goes, it is just enough of a challenge to get the two lower sections to be perfectly parallel to each other that I am going to design an all-in-one corner which will make the bottom of the printer easier to assemble.
Here's mine:
https://goo.gl/photos/UQNNqLhQ3m899gse9
In the group photo it is the small black/red one. The other 3 all have Duet 0.8.5 and I predict they will all be running Duet WiFi soon just because it makes FAR less noise.
David,
Thanks! The crazy dance after software reset is fixed for me too!
I have a Linux box sitting between my wired network and the wireless AP I was trying to connect to. In this case I was too quick to assume I was doing something wrong/stupid with the ESP setup process - when in fact the problem was a huge mess of netfilter policies I had implemented via a large iptables configuration script which got ugly over the years. I didn't even bother to track down what was causing me grief…. I deleted the entire mess I had in the config script and rewrote it as a very simple setup and cleaned up another mess in my DHCP server configuration and was able to connect and get the intended reserved address assignment on the first try after that (after I ascertained what MAC address it was using).
Next step will be to eliminate those possible points of failure which are no longer needed and simplify it all down to a single wifi router - and get back to printing!
BTW - Really liking how quiet the 1/16 stepping with interpolation is! And looking forward to future firmware you mentioned elsewhere which has dynamic optimization.
I followed the getting connected wiki page procedure with no success.
Hangs up here:
M552 S1
SENDING:M552 S1
WiFi server starting up
Then goes into AP mode again.
I know the password is correct for my router which only has 5 other devices connected to it and I'm 7 feet away from the router.
I will try a different router later this evening.
Can anyone point me to the idiot's guide to getting the ESP8266 board to connect to my wireless router? Or explain it?
I followed the steps mentioned in another thread about connecting to DuetWifi at 192.168.1.1 and setting the initial SSID and password values and rebooting - however it never comes back up as a wifi client device - just goes right back into DuetWifi server mode.
Thanks,
Jerry