Best posts made by jbarros

Just upgraded 2 panels, one 7" and one 5" and in both I had to force a set of a different baud rate in order to have communications:

115200 -> 57600 -> 115200

Reset or power cycle did not resolve.

@dc42

I confirm the issue on my 3 Z motor setup

@matt3o I too was going crazy for a while thinking I had slicer setting issues or something but it ended up getting worse and then I saw another thread with CAN issues on an expansion board and I started to be suspicious

You can try the beta firmware here:
https://www.dropbox.com/sh/wme9k0z86sytg33/AAAT6wrHp2eeJHK-dYoW1Um4a?dl=0
Note: you have to upgrade both 6HC and 1LC

@Dan1990 this was yesterday:

@dc42 said in Duet 3 Mini 5+ : Initial announcement:

We will have a limited number of pre-production boards next month. Full production and general availability will be Q1 next year.

@dc42 when I read your question it all made sense
I was wiring to the daughter board output pins but using the 6HC pinout.
Of course CS2 and CS3 will be on the daughter board's output pins at 6HC's CS0 and CS1 pinout!

I'll add something to the wiki to make it easier for the next guy.

Thank you Sir!

Just to close the loop, super speedy RMA process, new board has helped chew almost an entire spool of filament