Topics created by Ironman777

@droftarts so I was able to get the resume file to be created it just took some time for the capacitor to build a charge. Now the problem I have is with the offsets applied to make my print head square to the build plate the 0 position is off. When I press pause during a print it doesn’t return to limit switches it ends up coming up slightly short on X and Y.

My mistake, after reviewing old pictures and videos I had the 3wifi and replaced it with 6HC right before I stopped 3D printing.

If that's the case then the spelling is wrong and that's why it can't find the file.

@Ironman777 said in Heater N/A after 3.0 update:

its there
M950 H0 C"e0heat" T0 ; create nozzle heater output on e0heat and map it to sensor 0

thats not the M563 assignment

I assume you mean resume after power failure?

Firmware version? 12v? 24v?

Can you post your config and resurrect files?