Topics created by incogizmo

I have it connected to Endstop for E0.
DWC does not report the sensor, but it does appear in M112:

=== Filament sensors === Extruder 0: pos -1.74, ok, measured min 61% avg 76% max 96% over 3368.6mm, errs: frame 6 parity 0 ovrun 0 pol 0 ovdue 0

Im assuming since its not a switch and a laser filament sensor its not reporting as expected in the json.

All good will try and work around it.

You can already move the axes directly using the encoder in firmware 2.02RC5, as I expect you know already. The movement increment is 0.02mm for Z and 0.1mm for other axes. How would it be if I make the increment 1mm on all axes after a long press instead of a short one?

Thanks for your report. This is on my list to investigate.