Topics created by ianborg

@ianborg This is indeed a duplicate post and I've replied to your first one.

@ianborg As well as your wiring issue, it sounds like your part cooling fan might be too aggressive in that too much air is being directed at the nozzle/heater block. That would explain why you have problems PID tuning the tool, rather than just the heater. Unless you fix that, you could potentially get heater faults when the fan comes on during a print.

@droftarts Yeah I don't know how they got their either.
nodedfs was about 8k firmware folder was about 8mb
when i crafted the new card, I only added the folders that should be there and used a new webcontrol zip.
the only thing had to transfer over was the xml file.

Then just for future reference 😉

I will assume here you downloaded the firmware from the github repo.
As a part of the files there, you have a file called: DuetWebControl-SD-3.3b2.zip

That should help you out 😉

@bearer said in browser must be open to upload from s3d:

add a call to curl "http://192.168.x.xx/rr_connect" at the top?

@bearer Thanks.. that did the trick!

I'm curious as to what this turns out to be. Sometimes I feel like I'm playing wack-a-mole trying to set the height on my delta with a smart effector. I don't seem to have this problem on my cartesian.

@infiniteloop said in has anyone see this problem before (bltouch/bed):

didn’t find that in the specs. Is there any possibility of the 4 treaded rods coming out of sync, for either electrical or mechanical reasons?

The FT5 homes to the back right corner 0,0

Then, I think your mesh shows a look from the back, but anyway, that does’n matter.

my next step is to replace the bltouch and hope it has something to do with that?

Whatever BLtouch or other probe you take, you must make sure that it is trustworthy, so you should repeatedly probe a single point with G30 S-1 and look if the reported values are identical or at least very narrow.

originally it had 2 z motors wired in series? off of 1 z driver, but the R2 version used a single Z motor with bigger belt so allot of us that had R1 machines also converted over to a single Z.
to your other question, if i had the original melamine parts, then i would say yes possible, but that is why many people started getting the milled aluminum parts to replace. if you were curious check out 713maker.com that's the guy who makes all the aluminum conversion parts.

Thanks for the info. I will check out the links!