I used blind joints with my Misumi extrusions and it was worth every penny! Misumi's cuts were spot on and when done, no angle was off my more than .3 degrees using my digital square. And SOLID as a rock to! Thanks to @Nuramori for the suggestion!
Best posts made by I_Jedi
-
RE: My BLV MGN cube build/upgrade saga (ongoing)posted in My Duet controlled machine
-
RE: Critique my BLV cube toolchanger draft!posted in General Discussion
@whopping-pochard Outstanding, thank you! I am close to bringing my 're-mixed' BLV MGN online. (remixed as in borrowed ideas from all over the smashed them together in 3Dbuilder since I have no CAD skills
-
RE: Issue with Rpi/Duet3/7" Display in Full Screenposted in Duet Web Control
OK, I'm stumped... after four days and 30 reboots of not working and having to full screen out for some inexplicable reason the display is properly going into full screen mode. I didn't change anything... weird.... Not complaining, but cautiously optimistic that I had an anomalous loose wire somewhere that bumped back into place
-
RE: BLV MGN Cubeposted in Duet Hardware and wiring
I am almost finished with my 500x500 triple Z BLV MGN, and went with Duet3 and Toolboard... best decision in my opinion.
The triple Z Axis is easily accommodated and the toolboard greatly reduces the wiring having to run out to the hotend. Still room for plenty of upgrades with the flexibility of the IO ports being able to accommodate just about anything you would want to hook into it.Well worth the extra cost, in my opinion.