Topics created by Hugues

Hi DC 42, Pilotltd,

Pitch is close to 2mm so like leadskew pitch, i will re-check all my bed dans redo test !

Thanks for your help !

Ok my duetwifi board is a prototype, pin was not the same….

Great thanks !

The filament monitor uses a relatively simple protocol to send the angle to the Duet every 50ms or so. I have not written up the documentation for the protocol yet, once I do then you could use a MCU to interface any encoder to the Duet using this protocol.

I should not be by default if it's not in you start gcode or config.g but to be sur you can send M572 D0 S0 to disable it.

The stall detection isn't reliable at low speeds and the stalled status is only updated once every full step. So the stalled status should be ignored unless the motor is moving at a reasonable speed, or trying to. Also, the stall detection really needs to be tuned to the type of motor you are using. I'll probably add some sort of auto tuning for it in a future release.

I find the faulty guy… simply3d ! I spend an half day to figure out what's happen and slir3r did the job perfectly...

@pablo said in Going to plug external driver:

i have the same problem. I going to connect 2 nema 23 to Z and 2 nema23 to Y. which driver you recommend guys ?? please try to recommend something cheaper than the leadshine ESD 508... thanks !!!

If they are rated at no more than about 2.8A then one possibility is to use a Duet+DueX5 or DueX2. There is a wide choice of 2.8A Nema 23 motors here https://www.omc-stepperonline.com/nema-23-stepper-motor/filter/146-rated-current-a,2.8.

Here are some more possible reasons for shifted layers http://reprap.org/wiki/Shifted_layers

Thanks for your reply ! I will check this. I will try to figure out why my makerbot profiles have been mixed with with core xy….

Ok, sorry i re-upload firmware + duet server and rebooting all my wifi device and now it works.

Thanks for your fast reply.

It's exactly my wish !

Cool design.

Adding the ability to trigger a pause using one of the expansion header pins would be useful, we cant replace the erase button though because if invalid firmware is uploaded to a board, erase is required to reset the board so valid firmware can be uploaded via USB.

I am sure that your M307 parameters are wrong - the H0 and H1 parameters look the wrong way round to me. A heater with gain 97 will top out at around 120C - which sounds much more like your bed heater than your extruder heater.

Thanks !

Ok for max draw, i will check this.
I 've ordered this motor : Leadshine Close Loop system NEMA 23 motor ISS57-10
Waiting for them now…

@dc42:

If you haven't started that yet, you might like to try the 1.15 beta 3 release for the wired Duet that I just put on github.

sorry David, was sort of warmish today so got on with it, going to update the other thread with some details.

Cheers