@philipp-r - thanks i will look into this when i get a chance!
Latest posts made by haydenkrause
-
RE: Delta Frame Compensation
-
RE: Delta Frame Compensation
@haydenkrause - these are all Delta oriented questions - sorry - not clear above
-
Delta Frame Compensation
This ones for the Devs...
1: I am aware of your G32 command obviously as I run this before each print. First question is... can i save the values from the G32 command so i dont have to run this before every print??
2: Is it possible for me to be able to save G28 bed maps at different temperatures so i can save these for use with different materials?
3: Delta frames comming from china are not great as you would expect. I would like a way of fully compensating for frame miss-alignments. If i were to print a 2D square on the build plate (as large as the build plate will allow) this will not quite come out square. If i had the ability to peel this single layer square off the build plate, and compare it to a scale printed square on a piece of paper i could get a decent measurement of how far out the square is from being streight. It should then be possible to put xy offsets into the firmware to compensate.
Any or all of these might be possible... if not i would really like the functionality.
Thanks.!
-
RE: Wifi not connecting after firmware install. Duet2 Wifi
Thanks Phaedrux, i will do. I am sticking with 2.05 for now because I managed to get my 3 pin switch type z probe working. I tried everything on RR3 and i just couldn't get it working. It was connected to the zprobein using sensor type5 as stated in the online instructions (as type 4 not supported). Config was pointed to zprobe in using C".......". I am following a few posts on here with people having the same issues currently unsolved - if they can solve them i will update.
thanks for the time to help!
-
RE: Wifi not connecting after firmware install. Duet2 Wifi
Shoot! cracked it..
The link i used was here:
https://duet3d.dozuki.com/Wiki/Firmware_Overview
scroll to "SD Card Structure" explains in full - lovely....
Thanks for ur help dude!
-
RE: Wifi not connecting after firmware install. Duet2 Wifi
ok - think i may have found it... ill try this thx
-
RE: Wifi not connecting after firmware install. Duet2 Wifi
do i need to set that myself?
Following the "New Method" i dont have to add this...
-
RE: Wifi not connecting after firmware install. Duet2 Wifi
Ok. So tried all the above in formatting FAT32 etc, putting the following files on the SD card...
sys (from configuration tool)
gcode (empty folder)
macros (empty folder)I am seeing my wifi LED on. But i cant connect using the IP address
-
RE: Wifi not connecting after firmware install. Duet2 Wifi
ah ok - miss read that
thank for ur help btw!
-
RE: Wifi not connecting after firmware install. Duet2 Wifi
My SD Card is in place. Above says its not detecting one...