I didn't get chance to play around with the duet3 yesterday but I formatted the SD card using the mentioned program and get generated a new copy to transfer to my SD card (As below) does this look right? So now its a case of putting the SD card in and connecting to it?

Thanks

Good evening,

I have the duet3mb6ch, I've just taken delivery on a 2.2kw water cooled spindle, is there any recommended ways of wiring it to my CNC.

Hayden

Good afternoon,

I'm after some help setting up my CNC using the Duet 3 in standalone with ethernet.

I have it configured directly to my laptop using ethernet, not through a router.

I think everything is wired up correctly but I seem to be stuck setting the motors, when I click home all to see what happens and what needs changing I get one of the X motors move slightly then that's all. I can't get any of the others to move, can anyone help me please?

Thanks

@fcwilt much appreciated, thank you

I've now got it working straight to the laptop via ethernet.

I think it might be some settings in my router causing the connection issue

Hayden

Just about to add my limit switches on my CNC (X, Y, Z)

I've read a fair bit online and it seems better/safer to wire them as NC instead of NO?

Can I also confirm I'm wiring them correctly on my Duet3 6CH board

I0_1/2/3

3.3V = NC
GND = Gnd

Hayden

@dc42 said in Duet 3 ethernet connection issues:

Thanks,

I formatted it using the SD Card Formatter (Via download link in SD help section)

@siam

Thanks,

@siam

Good evening, as above I'm having issues getting my duet connected,

I'm trying to run it in standalone mode but having issues, can anyone assist me? (I've had it twice where I get an I.P back from the board but when I go to the I.P address I get the error

"Your duet rejected the http request: Page not found. Check that the SD card is mounted and has the correct files in its /www folder"

I've not changed any of these files since creating a new SD image?

Thanks

I didn't get chance to play around with the duet3 yesterday but I formatted the SD card using the mentioned program and get generated a new copy to transfer to my SD card (As below) does this look right? So now its a case of putting the SD card in and connecting to it?

Thanks