In versions below 2 it was possible to disable and remove the ATX power control in the #Dashboard. Many of us do not use ATX power supplies. Can you make this option selectable / disabled / Removed?
Best posts made by HarveyS
-
DWC 2.0 Release - ATX Power
-
RE: motor phase A may be disconnected reported by driver(s) 1
@HarveyS
@dc42
Just a quick reply to myself for anyone reading further on this thread.
Replaced the stepper motor with a 17HS08-1004S, set the current to 500 ma as others have used and low and behold - no phase A disconnect errors with Reprap version 2.04RC1. Even when over driving the extruder to the point where it chews filament, so problem solved. Now I can go on and start tuning / tweaking my slicer settings for best prints.
Thanks everyone.....