Hello,
after I rebuilt my IDEX printer, I wanted to do the software configuration today.
As described in the documentation, I moved the nozzle onto the print bed and set G92 Z0. After measuring the Z offset (0.8404mm) several times, I entered it in the G31 Command of config.g.
When I start a print with Tool 0, the nozzle is far too high above the print bed.
I do not understand that.
Anybody of yours offering an idea?
Thanks
gringo
Thanks oliof,
For example, if I take GND from out6, how to configure the M950 command?
M950 E0 C"out6"
Is that correct?
I have configured it like this:
M671 X-132:148:428 Y-25:385:-55 S5 ;Leadscrew Position
M208 X-88: 290 U0: 380 Y-25: 325 Z0: 270 ; Axis minima and maxima
I have now set a fan speed for Layers 1, 2 and 3 of 1%, 50% and 100% in S3D.
I let Tool 1 heat up first, so it works now.
Thanks for your help, the Board is running again. I first tried to flash the complete .zip file via BOSSA. Of course it does not work . After flashing the .bin I had to install the USB drivers.
After that I had no access with YAT. Pronterface then worked and I could set up the Network.
Thanks to all.
Please check your M671 command.
As I see, the Position of the Leadscrews does not match the Axis minima and maxima.
You write your Leadscrews are 50mm outside the print bed, then they can't be at X0.
M208 X0 Y0 Z0 S1
M671 0:215:450 Y80:450:80 S5
Thanks a lot.
I have modified your bed.g and now it works.
I have found the error. The color coding of the stepper cables did not match that of the Duet.
I had connected black/black, green/green, blue/blue, red/red.
But it must be black/black, green/red, blue/blue red/green.