Posts made by gorf32

With my smart effector it seems to work fine, probe good will do a bed mesh fine but only when the hotend is cool.
And if I heat up the hot end and try probing I keep getting false triggers and can not finish any probing while hot end is hot..

Any thoughts on what may be going on?

Thanks gary

@Phaedrux

No i didn't see that but i did do some searching before asking, it looks to me like what i thought connect to a heater pin i was using i think heater 6 but the doc's said heater 3 so that's the way i will try it.

Thanks

Nozzle wipe

What pin on a duet 2 would you connect a small servo to use for nozzle wipe?.
I thinking pa15 if that's available duet 2.

Thanks

@dc42 Thanks i did get it to work was a value of 400

@dc42 I don't know much about circuits, but i think this is the layout

@zapta Thanks I got it working sort of, it reading the temp but it seems to be about 20c to high when cold i am getting a value 43c cold it should read around 23 to 25c

thamks

looking to see if i can find the pin values for duet MAX31856 connected to the duet2 wifi v1.03

pin referring to:
sensor_pin: PB14 -- I think this is correct
spi_speed
spi_bus ?
sclk_pin ?
mosi_pin ?
smiso_pin ?

any help would be great

Thanks gary

I am looking for a 365mm round flex build plate.

Has anyone seen any at this size, or is there a company that makes custom sizes in only one or two pieces.?

Or is there a way to cut one down without ruining it?.

Thanks Gary

I hooked up a EBB36 canbus to the duet2 and a smart effector,

the out put voltage on the EBB probe plug shows 5+ and the smart effector shows 3.3+
will the smart effector except 5+ volts or will it blow..

it also has two pins on the EEB PB8 and PB9, does anyone know what pin would go to the smart effector Z probe Mod or Z probe Output or both?

Thanks gary