Best posts made by gabrealek

@Phaedrux YESSS !! it worked perfectly!!

@Phaedrux Okay i looked up the issue and found YOU lol, going to PID tune the bed. .

@Phaedrux Fixed it and was able to get it heated up to 180,
Now when i try to get the bed heated i get this

Error: Heater 0 fault: temperature rising much more slowly than the expected 1.8°C/sec

@Phaedrux
M308 S1 P"e1temp" Y"thermistor" T98801 B4185 ; configure sensor 1 as thermistor on pin e1temp
M950 H1 C"e1heat" T1 ; create nozzle heater output on e1heat and map it to sensor 1
M307 H1 B0 S1.00 ; disable bang-bang mode for heater and set PWM limit

I think its this line here maybe??
M143 H1 S80 ; set temperature limit for heater 1 to 80C

@fcwilt ok ill try . thanks