Best posts made by FuseDeep

@T3P3Tony

The original igus steppers were rated at five point something amps. apparently. Its the 600 x 600 room with the very deep top beam:

I got a lot of conflicting info early on, so swapped them out for some decent regular nema 23.

Am pretty sure it is just too chunky and have given up on it. I'll try it on a duet and if not swap it for a buzz automation set up. It's wasted too much of my time time at this point tbh.

Substantially quicker and cheaper to change the gantry than keep chasing my tail. especially now with losing the painful marlin settings.

R

I canged the z/E1 output MA from 800 to 1600 and it is much happier (0nly cost me 100gbp to not fix this!).

Seems it needed more current. will relube and see how she runs!

Morning all, thanks for your help recently. Have been distracted by a recent major show of 2 of my sculpture pieces (each partially 3dprinted) at Tate Late:

Son.im/Shhare

Son.im/Quotem

However...now back to Fusedeep!

Regarding the DUET wifi/Ethernet. Not all my laptops have Ethernet ports and am not always going to gave wifi hub.

Can either board just have gcode slotted in via SD card (appreciate both have an SD card firmware file also) . If I understand it correctly, the gcode of a print and firmware settings go in on the same SD card and it fires up. that would seem to be what i need?

If I know that no matter what I can use a screen to start a print via SD card (regardless of wifi/ethernet) then I will probably go wifi (though 2 duet experienced friends advised against it!).

your advice appreciated. Bit conflicted currently but like the simple on card option with screen. Reliable if i am in the middle of a field, and yest, this is very possible.

R

Very happy to share a vimeo of an early test print. Tech and print info on video description:

https://vimeo.com/382582071

Thanks for all your help so far.

R

@phaedrux

Thanks

Led removed from z endstop and all rehashed. Board back to life!

Weird

Only thing is z home works but does not do slow 5mm return as per other axis.

Fans put to 0 for work piece and 1 for extruder seem to be happy.

Assigning extruder trickier. It is heating up fine by web control but not un greying on web control extrude buttons, even past 180 degrees...

Nearly there!

Sorry if I was painful. It's been a really crappy week and I thought this would be the simple bit...

@phaedrux

Last thing (except for no z home bounce check)

I just put T0 at the end, below wifi line and it now let's me extrude!

Is that correct?

Hi,

Thanks all for help so far. I was despairing!

Last few things;

1/ when I cancel a print, bed and ext remain hot. Would like them to both shut down on cancel, assume that is sensible?

2/
Z home, works great but does not do the slow 5mm return check. Should it? How do I enable in homez please?

3/bed heats up, then extruder in order. Is that correct? Can they both heat in parallel to save time?

Seems to be it currently...

Thanks Rich.

Ps. Am feeling less desolate now!

@droftarts

Yes, exactly as Ian said.

Thank you so much everyone above for your constructive suggestions and comments.

I have now stopped sobbing into my keyboard!

And written the password clearly on each machine.