Topics created by flipps

@flipps does each fan spin when you connect it to the always-on fan output instead of to the Fan0 or Fan1 output?

https://www.filastruder.com/products/duet-connector-kit-1

Hi, I think there is no Problem with the Cabel, i tested it with another Duet Wifi with other Cabels, i will take some Photos today in the evening 🙂

from your config

M915 X Y S3

this does not look like a fine tuned M915 command

you have configures no action to be taken.

you are not changing current nor have taken care of the minimun speed.

Ok i will try, Thank you 🙂

Did you see my post in which I gave the cause of the "crinkle crisp" height map, and possible solutions?

You should not need to add H corrections to the probe points when using the Smart Effector, or any other type of nozzle contact Z probe. They are only needed when using an offset Z probe on a delta printer, to compensate for any varying tilt of the effector.

here is the one without the metal ring
https://e3d-online.com/embedded-bowden-collets-for-metal-1-75mm-filament

@t3p3tony said in New Smart Effector with Problem.:

@flipps please test the Smart effector to make sure it works. That looks like the programming pads cleared to make better contact for programming the firmware.

Thanks for your answer, i will test soon ✌