It does indeed work. Thanks a lot !

Hello,

In order to indicate to my domoticz server when a print is complete, paused or... anything else I find usefull, I'd like to be able to send Json commands to my domoticz server through execution of the associated macros (Print complete, Pause... etc...).

Is there a way to do that ?

Thanks for your help.

I used a pump like the one you described, and it died after maybe 100 hours. The plastic melted from friction where the excentric shaft moves the pump plate.
The motor is noisy, but the pump by itself is as well.
I'm not buying another...

I want to 3D print a 'CPAP like' blower, powered by a brushless R/C motor, just like you described. Will see, but i'm confident it should work.

It does indeed work. Thanks a lot !

I knew I could count on you guys !

Thanks a lot, heading my way to the garage now !

Hello,

It might be a crazy stupid idea, but I wanted to try setting a dual motor configuration for my extruder. Idea is to have a strong Bondtech on the remote side of a bowden, and a very light but therefore weak cold end extruder on the platform of my delta.
This way I would have power, but also the ability to print flexible, while keeping my platform to a reasonable weight.

I'm trying to configure the board using M584 command :
M584 X0 Y1 Z2 E3: 4

It just will not work : I believe that when you do like so, you map channel 3 for E0 and channel 4 for E1. Is that so ?

Is there a work around ? Something like mapping Extruder to a dummy channel, and then mapping that dummy channel to 2 motors ? Does it make sense at all ?

Thanks for you replies,
G.

Hello,

I own a (hacked) Xiaomi Dafang IP Camera, and am trying to plug it into Duet Control.
I configured the cam to output a rtsp/MJpeg stream.

In Duet settings, I entered the address : "local camera IP/cgi-bin/currentpic.cgi"

A still image is displayed on print status page, but will not update it every 5 seconds as configured.
If I enter this very same address in my browser, I also get a still image, but if I refresh the page, the image is refreshed too.

My first question is : what is going on ? Why isn't the image refreshed ?

Second question is : The cam is motorized. For example, I can move it right entering in my browser "local camera IP/cgi-bin/action.cgi?cmd=motor_right"

Has anyone added these kind of controls in duet web ? How easy would it be ?

Thanks for your replies.

G.